Honeywell BENDIX/KING KLN 94 Pilot's Manual page 120

Chapter 4 Flight Plan Operation
are: KNEW (Lakefront airport), GPT (Gulfport VOR), SJI (Semmes VOR),
CEW (Crestview VOR), MAI (Marianna VOR), SZW (Seminole VOR),
CTY (Cross City VOR), and KPIE (St. Petersburg/Clearwater International
airport).
To create a flight plan:
1. Select the flight plan (FPL) pages with the right outer knob.
2. Select a flight plan page (prefer-
ably other than FPL 0) which
does not contain a flight plan (fig-
ure 4-1). If all of the flight plan
pages contain flight plans, refer
to section 4.1.6, "Deleting Flight
Plans".
3. Turn on the cursor with the B button.
NOTE: The KLN 94 flight plan operation is designed so that the first way-
point in the flight plan should always be the departure airport. Remember
to enter the K, P, or C prefix for certain airports in the United States,
Alaska (some, but not all cases), or Canada, respectively. See section 2.3,
"ICAO Identifiers".
4. Use the right inner knob to select the first character of the departure
waypoint identifier (figure 4-2). If you have set the default first way-
point character to K on the
SET 11 page, you will just need
one turn clockwise (see section
3.4.2, "Data Entry").
5. Turn the right outer knob to
move the flashing part of the cur-
sor over the second character,
then select the desired charac-
ter.
6. Use the above procedure to
select the entire identifier for the
first waypoint (figure 4-3).
7. Press F. A waypoint page for
the identifier just entered will be
displayed on the screen (figure
4-4). If a mistake was made and
the wrong waypoint identifier was
entered, press E and begin
Figure 4-1
Figure 4-2
Figure 4-3
Figure 4-4
4-2