Honeywell BENDIX/KING KLN 94 Pilot's Manual page 45

KLN 94 Pilot's Guide
2. Use the right inner knob to enter the current altimeter setting into the
"Baro" field and then press the F button. (If the KLN 94 is inter-
faced to a compatible airdata system you will not be able to enter data
into this field. Verify that the data displayed on the Self Test page is
the same as is being displayed on the appropriate equipment in the
aircraft which is interfaced to the KLN 94. If the KLN 94 is not con-
nected to any other equipment in the aircraft, you may skip to step 3.
The distance field in the upper left corner always displays 34.5 NM (or
63.9 km). If the KLN 94 is interfaced to a compatible indicator that dis-
plays DME distance, the indicator should be displaying 34.5 nautical
miles.
If the KLN 94 is interfaced with a NAV indicator such as an HSI or a
course deviation indicator (CDI), the deviation bar (D-bar) should be
indicating a half scale deviation to the right. The TO/FROM indicator
should be showing FROM.
If the KLN 94 is interfaced with a NAV indicator such that the KLN 94
can "read" the selected course from the NAV indicator, then the OBS
field should display the same selected course as on the NAV indica-
tor.
The RMI field always displays 130 degrees. If the KLN 94 is connect-
ed to a compatible RMI in the aircraft, the RMI should indicate a
bearing to the station of 130 degrees.
If any of the above checks fail, do not use the associated indicator
with the KLN 94.
3. If the KLN 94 has passed the internal self test, the bottom of the Self
Test page will display Pass and all external annunciators (if any
installed) should be illuminated. If instead, Fail is displayed, recycle
power to the KLN 94. If the Self Test page still displays Fail, the
KLN 94 requires repair and should not be used for navigation.
4. Use the right outer knob to position the cursor over OK? if it is not
already there. When you are ready to approve the Self-test page,
press the F button.
5. The next page displayed will be
the Initialization page (figure 3-
7). Verify that the date displayed
in the top left corner of the
Initialization page is correct.
Chapter 3 Basic GPS Operation
Figure 3-7
3-3