Viewing Distance And Desired Track Between Stored Flight Plan Waypoints; Activating A Numbered Flight Plan; Turn On The Cursor (B). It Will; Figure - Honeywell BENDIX/KING KLN 94 Pilot's Manual

Chapter 4 Flight Plan Operation
first three waypoints will then be displayed followed by the last way-
point in the flight plan. Rotate the right outer knob to move the cursor
and manually scroll to see the missing intermediate waypoints.
11. Turn off the cursor with the B button. Additional flight plans may
now be created in the same manner.
4.1.2. VIEWING DISTANCE AND DESIRED TRACK BETWEEN
STORED FLIGHT PLAN WAYPOINTS
The stored flight plan (FPL 1-25) pages have a field to the right of each
waypoint in the flight plan. This field may be used to display the cumula-
tive distance (Dis) to each waypoint or the desired track (DTK) from the
previous waypoint.
If you have more than four waypoints in the stored flight plan, you may
wish to view flight data for waypoints which are not displayed on the
screen. If this is the case, turn on the cursor (B) and use the right outer
knob to scroll down the flight plan until the waypoint of interest is on the
screen.
This display will default to the distance presentation at power-on.
To change between distance and desired track display on a num-
bered flight plan page:
1. Turn on the cursor (B); it will
come up over the USE? field
near the upper left corner of the
screen. Rotate the outer knob to
position the cursor over the dis-
tance (Dis) field (figure 4-8).
2. Turn the right inner knob one
click to change to desired track
(DTK) (figure 4-9). An additional
click changes back to Dis.
4.1.3.

ACTIVATING A NUMBERED FLIGHT PLAN

To activate one of the previously created numbered flight plans:
1. Use the right outer and inner
knobs to select the desired flight
plan page (figure 4-10).

Figure 4-8

Figure 4-9
Figure 4-10
4-4