Adjusting Height; Installing/Removing Flip Back Armrests; Installing - Invacare Pronto M50 Owner's Manual

Adjusting Height

NOTE: For this procedure, refer to FIGURE 6.4.
1. Remove the socket screw that secures the armrest to the seat frame assembly.
2. Adjust the armrest to one (1) of four (4) positions.
3. Reinstall the socket screw that secures the armrest to the seat frame assembly and
tighten securely.

Installing/Removing Flip Back Armrests

Make sure the flip back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 6.5.
NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the
arm sockets.

Installing

1. Slide the flip back armrest into the arm sockets on the wheelchair frame.
2. Install the quick release pin through the rear arm socket and flip back armrest.
3. Lock flip back armrest by pressing flip back armrest release lever into the locked
(vertical) position.
4. Lift up on flip back armrest to make sure the armrest is locked in place.
5. Repeat STEPS 1-4 for opposite flip back armrest.
Part No. 1125085
Height
Adjustment
Holes
Lock Knob
FIGURE 6.4 Adjusting Height
WARNING
45
Armrest
Arm Frame
Assembly
Pronto® M50™, M51™and M61™with SureStep™
SECTION 6—ARMS