Engaging/Disengaging Motor Release Lever - Invacare Pronto M50 Owner's Manual

Center
Hole in
Top
Shroud
Joystick Cable
and Connector
Base
Frame
Hook and
Loop
Strap

Engaging/Disengaging Motor Release Lever

DO NOT engage or disengage the motor release lever until the On/Off switch on
the joystick is in the Off position.
Ensure both motor release levers are fully engaged before driving the wheelchair
NOTE: For this procedure, refer to FIGURE 10.2.
NOTE: The motor lock disengagement/engagement allows freewheeling or joystick controlled
operation. Freewheeling allows an attendant to maneuver the wheelchair without power.
1. Locate the motor release handles on the motors protruding through the top shroud on
the rear of the wheelchair.
2. Perform one (1) of the following:
• To Disengage the Motor Release Levers - Pull the motor lock lever towards the rear
of the wheelchair (freewheel position).
NOTE: This allows the chair to freewheel for pushing, if necessary.
NOTE: It may be necessary to rock the wheels slightly until the motor release lever disengages.
• To Engage the Motor Release Levers - Push the motor lock handles towards the
front of the wheelchair (drive position).
NOTE: This allows the motors to drive the wheels.
NOTE: It may be necessary to rock the wheels slightly until the motor release lever engages.
Part No. 1125085
Shroud
Hook and
Loop Strap
FIGURE 10.1 Removing/Installing the Top Shroud
WARNING
CAUTION
SECTION 10—TOP SHROUD AND WHEELS
DETAIL "A" - M61 TOP SHROUD
Top
Clip
Front
Shroud
NOTE: Batteries not
shown for clarity.
73
Pronto® M50™, M51™and M61™with SureStep™