Section 10-Top Shroud And Wheels; Replacing The Flat Free Tires On The Wheel Rim; Removing/Installing The Top Shroud; Removing - Invacare Pronto M50 Owner's Manual

SECTION 10—TOP SHROUD AND WHEELS
SECTION 10—TOP SHROUD AND
WHEELS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.

Replacing the Flat Free Tires on the Wheel Rim

DO NOT attempt to replace flat free tires. This procedure MUST be performed by
a qualified technician.
NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat
spots will vanish with continued use of the wheelchair.

Removing/Installing the Top Shroud

NOTE: For this procedure, refer to FIGURE 10.1.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 90.
2. M61 Wheelchairs Only - Remove the joystick cable from the clip on the top shroud.
3. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 50.
4. Remove the top shroud by pulling it up off the base frame.

Installing

1. Pull joystick cable through the center hole in the top shroud.
2. Place the top shroud on the base frame and push downward to engage the hook and
loop straps.
3. M61 Wheelchairs Only - Secure the joystick cable using the clip on the top shroud.
4. Install the seat assembly. Refer to Removing/Installing the Seat Assembly on page 50.
5. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 90.
Pronto® M50™, M51™and M61™with SureStep™
WARNING
WARNING
72
Part No. 1125085