Invacare Pronto M50 Owner's Manual page 54

SECTION 7—SEAT
3. Perform one (1) of the following:
• To Reduce Seat Height by One (1) Inch - Remove one (1) set of 1-inch adjustment
spacers to achieve desired height.
• To Reduce Seat Height by Two (2) Inches - Remove both sets of 1-inch adjustment
spacers to achieve desired height.
4. Perform one (1) of the following:
NOTE: The seat comes installed with four (4) 1-inch spacers secured by either 3-inch or 3½-inch
mounting screws. 1-inch, 2-inch, and 2½-inch mounting screws are supplied with the seat.
• For Seat Height Reduced by One (1) Inch -
i. Align the mounting holes on the seat adapter plate with the mounting holes on
the adjustment spacers and either the seat mounting bracket on standard van
seats or the seat base on office style van seats.
ii. Install the seat adapter to seat base using the 2-inch mounting screws and
existing washers and locknuts (if required). Securely tighten.
• For Seat Height Reduced by Two (2) Inches -
i. Align the mounting holes on the seat adapter plate with the mounting holes on
the adjustment spacers and either the seat mounting bracket on standard van
seats or the seat base on office style van seats.
ii. Install the seat adapter to seat base using the 1-inch mounting screws and
existing washers and locknuts (if required). Securely tighten.
5. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 50.
Spacers should be placed in orientation shown, otherwise they will interfere with
the seat lever.
Pronto® M50™, M51™and M61™with SureStep™
CAUTION
54
Part No. 1125085