SECTION 9—FRONT RIGGINGS
Inner Mounting Holes
Seat Frame
FRONT RIGGING
MODEL
PHW93
PH904A and PHAL4A
FIGURE 9.7 Adjusting/Replacing Telescoping Front Rigging Supports - Standard Seat
ASBA Seat
NOTE: For this procedure, refer to FIGURE 9.8.
1. Remove the two (2) mounting screws, spacers and locknuts that secure the telescoping
front rigging support to the seat frame.
2. Perform one (1) of the following:
• Slide existing telescoping front rigging support to one (1) of three (3) depth
positions.
• Remove existing telescoping front rigging.
3. Secure telescoping front rigging at desired depth with existing two (2) mounting
screws, spacers, and locknuts. Securely tighten.
Pronto® M50™, M51™and M61™with SureStep™
Locknuts
Mounting Holes
STANDARD
POSITION
18 inches
20 inches
wide
wide
Holes
Holes
4 and 5
4 and 5
Holes
Holes
3 and 4
3 and 4
70
Mounting Bolts
Telescoping Front
Rigging Support
Spacer
8
8
7
6
5
4 3
2
Not Used
1 INCH OUT
18 inches
20 inches
wide
wide
Holes
Holes
5 and 6
5 and 6
Holes
Holes
4 and 5
4 and 5
Hinge
Pins
2 INCHES OUT
18 inches
20 inches
wide
wide
Holes
Holes
6 and 7
6 and 7
Holes
Holes
5 and 6
5 and 6
Part No. 1125085