Section 6-Arms; Removing/Installing The Arms - Invacare Pronto M50 Owner's Manual

SECTION 6—ARMS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.

Removing/Installing the Arms

Increasing the width of the arms may affect the overall width of the wheelchair.
Ensure that there is enough clearance when attempting to pass through doorways
or other tight spaces, otherwise serious injury or damage may result.
NOTE: For this procedure, refer to FIGURE 6.1.
NOTE: Reverse this procedure to install the arms.
1. Loosen lock knob that secures the arm to the arm support tube.
2. Remove the arm from the arm support tube.
3. If necessary, repeat STEPS 1-2 to remove the other arm.
Part No. 1125085
WARNING
WARNING
Lock
Arm Support
Knob
FIGURE 6.1 Removing/Installing the Arms
43
Seat
Arm
Tube
Pronto® M50™, M51™and M61™with SureStep™
SECTION 6—ARMS