Section 8-Footboard Assembly; Removing/Installing The Footboard Assembly; Removing; Installing - Invacare Pronto M50 Owner's Manual

SECTION 8—FOOTBOARD
ASSEMBLY
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
Limited Clearance Between Footboard and Caster - The user's feet MUST remain
on the footboard while operating the chair. If the user's feet are allowed to rest off
the side of the footboard they may come in contact with the caster possibly result-
ing in injury.

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 8.1.

Removing

1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.

Installing

Make sure the detent balls are engaged with the outer edge of the tube - otherwise,
injury and/or damage may result.
1. Position the footboard assembly onto the wheelchair frame so that the mounting hole
in the wheelchair frame aligns with the desired mounting hole in the footboard
assembly.
2. Install the quick release pin by depressing the button while sliding the pin in. Ensure
that the detent balls are engaged with the outer edge of the tube (Detail "A" of
FIGURE 8.1).
Part No. 1125085
SECTION 8—FOOTBOARD ASSEMBLY
WARNING
WARNING
61
Pronto® M50™, M51™and M61™with SureStep™