Invacare Pronto M50 Owner's Manual page 80

SECTION 11—BATTERIES
DO NOT remove fuse or mounting hardware from POSITIVE (+) RED battery
cable/mounting screw.
Battery terminal configuration as shown in Detail "A" of FIGURE 11.4 MUST be
used. Batteries that have the terminal configuration reversed MUST NOT be used -
otherwise serious injury or damage may occur.
Install protective caps on POSITIVE (+) and NEGATIVE (-) terminals.
All battery terminal covers (two [2] on the front battery and two [2] on the rear
battery) MUST be installed prior to use.
NOTE: For this procedure, refer to FIGURE 11.3 and FIGURE 11.4.
1. Install RED battery terminal cap onto RED battery cable (FIGURE 11.3).
2. Install GREY battery terminal cap onto BLACK battery cable (FIGURE 11.3).
When connecting the battery cables to the battery(ies), the battery cable(s) MUST
be connected to the battery terminal(s)/post(s), as shown in Detail "A" of
FIGURE 11.4 (depending on battery type), otherwise damage to the battery cable
may result when installing battery terminal caps.
3. Connect battery cable(s) to battery(ies) terminal(s)/post(s) (FIGURE 11.4):
A. NEGATIVE (-) BLACK battery cable to NEGATIVE (-) battery terminal/post.
B. POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post.
4. Secure the battery cable(s)/ring terminal(s) to the battery terminal(s)/post(s), BLACK
to NEGATIVE (-) and RED to POSITIVE (+), with the provided 1/4-20 x 5/8-inch hex
flange screw and hex flange locknut. Securely tighten. Refer to Detail "A" of
FIGURE 11.4.
5. Verify all battery cable(s)/ring terminal(s) are correctly installed and securely
tightened.
6. Slide terminal cap(s) down battery cable(s) and onto battery clamps (FIGURE 11.3).
7. Secure each terminal cap in place with a tie-wrap [use tie-wraps 11-1/2-inches long]
(Detail "B" of FIGURE 11.4).
Pronto® M50™, M51™and M61™with SureStep™
WARNING
CAUTION
FIGURE 11.3 Connecting Battery Cables
80
Battery Cable
Battery Terminal Cap
Part No. 1125085