Create An Ipv4 Client-To-Gateway Vpn Tunnel With The Wizard - NETGEAR ProSafe FVS318N Reference Manual

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 113.
b. Locate the policy in the table, and click the Connect table button. The IPSec VPN
connection becomes active.
Note: When using FQDNs, if the Dynamic DNS service is slow to update
its servers when your DHCP WAN address changes, the VPN tunnel
will fail because the FQDNs do not resolve to your new address. If
you have the option to configure the update interval, set it to an
appropriately short time.

Create an IPv4 Client-to-Gateway VPN Tunnel with the Wizard

Figure 114.
To configure a VPN client tunnel, follow the steps in the following sections:
• Use the VPN Wizard to Configure the Gateway for a Client Tunnel
• Use the NETGEAR VPN Client Wizard to Create a Secure Connection
Manually Create a Secure Connection Using the NETGEAR VPN Client
Virtual Private Networking Using IPSec and L2TP Connections
198
on page 199.
on page 201 or
on page 206.