NETGEAR ProSafe FVS318N Reference Manual page 251

Table 60. VPN client IPSec configuration settings (Mode Config) (continued)
Setting
ESP
PFS and Group
4. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
Configure the Mode Config Global Parameters

To specify the global parameters:
1. Click Global Parameters in the left column
Global Parameters pane displays in the
Figure 151.
2. Specify the following default lifetimes in seconds to match the configuration on the wireless
VPN firewall:
• Authentication (IKE), Default. Enter 3600 seconds.
• Encryption (IPSec), Default. Enter 3600 seconds.
Virtual Private Networking Using IPSec and L2TP Connections
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Description
Encryption Select 3DES as the encryption algorithm from the drop-down list.
Authentication Select SHA-1 as the authentication algorithm from the drop-down list.
Mode Select Tunnel as the encapsulation mode from the drop-down list.
Select the PFS check box, and then select the DH2 (1024) key group from the drop-down
list.
Note: On the wireless VPN firewall, this key group is referred to as Diffie-Hellman
Group 2 (1024 bit).
of the Configuration Panel screen.
Configuration Panel screen:
251
The