NETGEAR ProSafe FVS318N Reference Manual page 115

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Table 28. Add Wireless Profiles screen settings (continued)
Setting
Encryption
Note: WPA, WPA2, and
WPA+WPA2 only.
Authentication
Note: WPA, WPA2, and
WPA+WPA2 only.
WPA Password
Note: WPA, WPA2, and
WPA+WPA2 only.
Enable
Pre-Authentication
Note: WPA2 only.
Radius Server Settings
Note: WPA, WPA2, and
WPA+WPA2 only.
VLAN
VLAN Profiles
Active Time
Start Time
Stop Time
WLAN Partition
Description
The encryption that you can select depends on the type of WPA security that
you have selected:
• WPA. You can select the following encryption from the drop-down list:
- TKIP
- TKIP+CCMP
• WPA2. You can select the following encryption from the drop-down list:
- CCMP
- TKIP+CCMP
• WPA+WPA2. The encryption is TKIP+CCMP.
For WPA, WPA2, and WPA+WPA2 only, specify the authentication by making a
selection from the drop-down list:
• PSK
• RADIUS
• PSK+RADIUS
For WPA, WPA2, and WPA+WPA2 only, if you have selected PSK or
PSK+RADIUS authentication, enter a pre-shared key or password.
For WPA2 only, if you have selected RADIUS authentication, configure
preauthentication by selecting the check box. Preauthentication allows a client
to roam from one access point to another access point without having to be
reauthenticated.
For WPA, WPA2, and WPA+WPA2 only, if you have selected RADIUS or
PSK+RADIUS authentication, click the Radius Server Settings link to
configure the RADIUS settings (see
on page 235).
From the drop-down list, select the VLAN to which the wireless profile should
be allocated.
Click the VLAN Profiles link to configure a VLAN profile (see
VLAN Profile on page 56).
To enable the timer, select the Active Time check box. When the timer is
enabled, the wireless profile is turned off from the start time until the stop time.
To disable the timer, clear the check box.
Specify the start hour in the Hours field and the start minute in the Minutes field,
and then select AM or PM from the drop-down list.
Specify the stop hour in the Hours field and the stop minute in the Minutes field,
and then select AM or PM from the drop-down list.
To enable wireless client separation and prevent wireless clients that are
connected to this wireless profile from communicating with each other, select
the WLAN Partition check box. To disable wireless client separation, clear the
check box. By default, WLAN partition is disabled.
Wireless Configuration and Security
115
RADIUS Client and Server Configuration
Configure a