NETGEAR ProSafe FVS318N Reference Manual page 247

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
3. Change the name of the authentication phase (the default is Gateway):
a. Right-click the authentication phase name.
b. Select Rename.
c. Type GW_ModeConfig.
d. Click anywhere in the tree list pane.
Note: This is the name for the authentication phase that is used only for the
VPN client, not during IKE negotiation. You can view and change this name in
the tree list pane. This name needs to be a unique name.
The Authentication pane displays in the
Authentication tab selected by default:
Figure 148.
4. Specify the settings that are explained in the following table.
Table 58. VPN client authentication settings (Mode Config)
Setting Description
Interface Select Any from the drop-down list.
Remote Gateway Enter the remote IP address or DNS name of the wireless VPN firewall. For example,
enter 192.168.15.175.
Preshared Key Select the Preshared Key radio button. Enter the pre-shared key that you already
specified on the wireless VPN firewall. For example, enter H8!spsf3#JYK2!. Confirm
the key in the Confirm field.
Virtual Private Networking Using IPSec and L2TP Connections
Configuration Panel screen, with the
247