NETGEAR ProSafe FVS318N Reference Manual page 250

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 150.
3. Specify the settings that are explained in the following table.
Table 60. VPN client IPSec configuration settings (Mode Config)
Setting Description
VPN Client This field is masked out because Mode Config is selected. After an IPSec connection is
address established, the IP address that is issued by the wireless VPN firewall displays in this field
(see
Address Type Select Subnet address from the drop-down list.
Remote host The address that you need to enter depends on whether or not you have specified a LAN
address IP network address in the Local IP Address field on the Add Mode Config Record screen
of the wireless VPN firewall:
• If you left the Local IP Address field blank, enter the wireless VPN firewall's default LAN
IP address as the remote host address that opens the VPN tunnel. For example, enter
192.168.1.1.
• If you specified a LAN IP network address in the Local IP Address field, enter the
address that you specified as the remote host address that opens the VPN tunnel.
Subnet mask Enter 255.255.255.0 as the remote subnet mask of the wireless VPN firewall that opens
the VPN tunnel. This is the LAN IP subnet mask that you specified in the Local Subnet
Mask field on the Add Mode Config Record screen of the wireless VPN firewall. If you left
the Local Subnet Mask field blank, enter the wireless VPN firewall's default IP subnet
mask.
Virtual Private Networking Using IPSec and L2TP Connections
Figure 155 on page 254).
250