NETGEAR ProSafe FVS318N Reference Manual page 16

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Power
Left LAN LEDs
(green, one for each port)
LED
Wireless LED
Test LED
Figure 1.
The following table describes the function of each LED.
Table 1. LED descriptions
LED Activity
Power LED On (green)
Off
Test LED On (amber) during
startup.
On (amber) during
any other time
Blinking (amber)
Off
Left WAN LED
Right LAN LEDs
(one for each port)
Description
Power is supplied to the wireless VPN firewall.
Power is not supplied to the wireless VPN firewall.
Test mode. The wireless VPN firewall is initializing. After approximately 2
minutes, when the wireless VPN firewall has completed its initialization, the
Test LED goes off.
The initialization has failed, or a hardware failure has occurred.
The wireless VPN firewall is writing to flash memory (during upgrading or
resetting to defaults).
The wireless VPN firewall has booted successfully.
Introduction
16
(green)
Right WAN LED
Active WAN LED
DMZ LED