NETGEAR ProSafe FVS318N Reference Manual page 136

• Edit. Allows you to make any changes to the definition of an existing rule. Depending on
your selection, one of the following screens displays:
- Edit LAN WAN Outbound Service screen for IPv4 (identical to
- Edit LAN WAN Inbound Service screen for IPv4 (identical to

To change the default outbound policy for IPv6 traffic or to make changes to existing
IPv6 rules:
1. Select Security > Firewall. The Firewall submenu tabs display with the LAN WAN
Rules screen for IPv4 in view
2. In the upper right of the screen, select the IPv6 radio button. The LAN WAN Rules screen
displays the IPv6 settings. (The following figure contains examples.)
Figure 62.
3. From the Default Outbound Policy drop-down list, select Block Always. (By default, Allow
Always is selected.)
4. Next to the drop-down list, click the Apply table button.
To make changes to an existing outbound or inbound service rule, in the Action column to the
right of to the rule, click one of the following table buttons:
• Up. Moves the rule up one position in the table rank.
• Down. Moves the rule down one position in the table rank.
• Edit. Allows you to make any changes to the definition of an existing rule. Depending on
your selection, one of the following screens displays:
- Edit LAN WAN Outbound Service screen for IPv6 (identical to
- Edit LAN WAN Inbound Service screen for IPv6 (identical to
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Firewall Protection
136
Figure 63 on page 138)
Figure 65 on page 140)
Figure 64 on page 139)
Figure 66 on page 141)