NETGEAR ProSafe FVS318N Reference Manual page 226

Figure 139.
Each policy contains the data that are explained in the following table. These fields are
explained in more detail in
Table 52. VPN Policies screen information for IPv4 and IPv6
Item
! (Status)
Name
Type
Local
Remote
Auth
Encr

To delete one or more VPN polices:
1. Select the check box to the left of each policy that you want to delete, or click the Select
All table button to select all VPN policies.
2. Click the Delete table button.
Virtual Private Networking Using IPSec and L2TP Connections
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Table 53 on page 230.
Description
Indicates whether the policy is enabled (green circle) or disabled (gray circle). To enable
or disable a policy, select the check box adjacent to the circle, and click the Enable or
Disable table button, as appropriate.
The name that identifies the VPN policy. When you use the VPN Wizard to create a VPN
policy, the name of the VPN policy (and of the automatically created accompanying IKE
policy) is the connection name.
Auto or Manual as described previously (Auto is used during VPN Wizard configuration).
IP address (either a single address, range of address, or subnet address) on your LAN.
Traffic needs to be from (or to) these addresses to be covered by this policy. (The subnet
address is supplied as the default IP address when you are using the VPN Wizard.)
IP address or address range of the remote network. Traffic needs to be to (or from) these
addresses to be covered by this policy. (The VPN Wizard default requires the remote
LAN IP address and subnet mask.)
The authentication algorithm that is used for the VPN tunnel. This setting needs to match
the setting on the remote endpoint.
The encryption algorithm that is used for the VPN tunnel. This setting needs to match the
setting on the remote endpoint.
226