NETGEAR ProSafe FVS318N Reference Manual page 358

IPv6 WAN Port Status

To view the IPv6 status of the WAN port:
1. Select Network Configuration > WAN Settings > Broadband ISP Settings (IPv6).
The Broadband ISP Settings (IPv6) screen displays (see
2. Click the Status option arrow in the upper right of the screen to display the Connection
Status pop-up screen. (The following figure shows a dynamic IP address configuration.)
Figure 215.
The type of connection determines the information that is displayed on the Connection
Status screen. The screen can display the information that is described in the following
table:
Table 89. Connection Status screen information for an IPv6 connection
Item
Connection Time
IPv6 Connection Type
IPv6 Connection Status The connection status can be either Connected or Disconnected.
IP Address
Gateway
DNS Server (IPv6)
Click Disconnect to disconnect the connection.
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Description
The period that the wireless VPN firewall has been connected through the WAN
port.
The connection type can be either Dynamic IP (DHCP) or Static.
The IPv6 addresses that were automatically detected or that you configured on
the Broadband ISP Settings (IPv6) screen.
Note: The Gateway and DNS Server (IPv6) fields apply only to a static IPv6
connection.
Note: For more information, see
Internet Connection
on page 39.
Monitor System Access and Performance
Figure 17
Use a DHCPv6 Server to Configure an IPv6
on page 37 and Configure a Static IPv6 Internet Connection
358
on page 38).