Connections; Transmitter - Extron electronics TP Series User Manual

Connections

transmitter

the tx transmitter rear panel (see figure 3) has a Dc power input, one USB host type B
female connector and a twisted pair link connection.
POWER
0.4A MAX.
Figure 3.
a
b
c
See
HOST
12V
DO NOT
CONNECT
TO LAN
a b
USB Extender Tx Rear Panel Connectors
Power Input Connector — One two-pole, 3.5 mm captive screw connector is used to
apply power to the transmitter from an external supply. If the USB port of a connected
Pc or laptop is capable of providing USB power, an external supply for the transmitter is
not required.
CAUtION: Always use a power supply provided or specified by Extron for the
USB Extender transmitters and receivers. Use of an unauthorized
power supply voids all regulatory compliance certification and
may cause damage to the supply and the USB Extender. Unless
otherwise stated, the Ac/Dc adapters are not suitable for use in air
handling spaces or in wall cavities. the installation must always be
in accordance with applicable provisions of National Electrical code
ANSI/NFPA 70, article 75 and the canadian Electrical code part
1, section 16. the power supply shall not be permanently fixed to
building structure or similar structure.
USB Host connector — connect a type A-B female USB cable between this port and
the USB output port of a Pc or laptop. the USB Extender is USB 2.0 compliant and able
to support data transfers of 480 Mbps (high speed), 12 Mbps (full speed) and 1.5 Mbps
(low speed).
Link (twisted pair) connector — connect the tP cable from the receiver link
connector (figure 4, item
CAUtION: Do not connect this port to a computer data or telecommunications
network.
TP Cable Termination on page
LINK
c
e
) to this RJ-45 female connector.
17, to properly wire the RJ-45 connectors.
USB Extenders • Installation and Operation 7