Table of Contents
Advertisement
through-Furniture Mounting
the transmitter or receiver can be mounted through a desk or other furniture using an
optional Extron MBD 129, through-Desk Mounting Kit for quarter or half rack width
products, part #70-077-02. Mount the transmitter or receiver through a desk or table as
follows (figure 15):
Figure 15.
1.
Loosely attach the mounting brackets to the transmitter or receiver using the four
machine screws and washers supplied with the mounting kit.
2.
Hold the transmitter or receiver against the inside of the surface through which it will be
mounted. Mark the four screw holes and the table material to be removed on the inside
of the surface to which you are mounting the device.
3.
Remove the table material. test the fit by inserting the front of the device through the
hole. If necessary, use a rasp or coarse file to enlarge the hole.
4.
Drill four pilot holes, each 3/32 inch in diameter by 1/4 inch deep, where the marks were
made.
5.
Using the provided four wood screws, secure the brackets to the mounting surface.
6.
Slide the transmitter or receiver up and down in the mounting brackets until the face of
the transmitter or receiver is at the desired height.
7.
tighten the screws that secure the brackets in place.
If the screws are inaccessible to a screwdriver:
a.
Mark the location of the brackets relative to the screws.
b.
Remove the transmitter or receiver from inside the furniture.
c.
Adjust the brackets to align with the marks made in step 7a.
d.
tighten the screws.
e.
Secure the brackets to the mounting surface (step 5).
Through-Furniture Mounting
USB Extenders • Reference Information
22
Advertisement
Table of Contents
