Final Installation; Transmitter Connections; Transmitter Front Panel - Extron electronics DTP DVI 4K 230 D Series User Manual

Final Installation

After testing and making any adjustments, do the following:
1.
2.
3.

Transmitter Connections

The DTP DVI 4K 230 D transmitter is in an enclosure that can be mounted in UL-listed
standard wall boxes with decorator-style face plates.

Transmitter Front Panel

Figure 4 shows the front panel of the DTP DVI 4K 230 D transmitter.
A
C
E
Figure 4.
A
B
At the power outlet, unplug the power supply.
NOTE: One power supply can power both the transmitter and the receiver (see
Power Supply Wiring
Mount the transmitter or receiver into the wall box or mud ring, and attach the supplied
decorator-style faceplate to the unit, as shown in
At the power outlet, reconnect the power supply. This powers up both units.
INPUTS
DVI-D
DDC
ROUTE
REMOTE
ON
AUDIO
1 2
LOCAL
DTP DVI 4K 230 D Transmitter Front Panel Connectors
DVI input connector — Connect a DVI cable between this port and the DVI output
port of the digital video source.
Local Out connector — Connect a DVI cable between this port and the DVI input of a
local monitor.
NOTE: In a system where the local output is not used, ensure that you power up
the end display before the video source. Route the DDC to the remote end (see
e on the next page).
DTP DVI 4K 230 D Transmitter and Receiver • Introduction
on page 11 and Ground Loops
figure 2
LOCAL OUT
B
RS-232 IR
D
Tx Rx G Tx Rx
on page 15).
on page 4.
6