Table of Contents
Advertisement
Projector Mounting
the receiver can be mounted on a projector bracket using either of the following optional
Extron projector mounting kits:
•
PMK 300 multi-product pole mount kit (part #70-374-01)
•
PMK 350 low profile, multi-product pole mount kit (part #70-563-03)
PMK 300 mounting
Mount the receiver to a PMK 300 bracket as follows:
1.
If necessary, remove the feet from the bottom of the receiver.
2.
Mount the receiver to one of the bracket's three mounting plates using two of the
supplied 4-40 x 3/16 inch screws in opposite (diagonal) corners to secure the device to
the bracket. It can be vertically mounted facing either up or down (figure 16).
Figure 16.
NOtE: On the side mounting plates, the device is typically mounted on the
3.
If the power supply is connected to the receiver, use the two included tie wraps to strap
the power supply to one of the brackets.
NOtE: the PMK 300 has a hole in the bottom plate that allows the projector
Bracket
Brace
U-Bolt
Back
Plate
PMK 300 Projector Mounting a Receiver
outside of the bracket.
On the front mounting plate, the device is typically mounted on the inside
of the bracket.
pole to be inserted through the center of the plate (figure 17), rather
than outside of the plate (figure 16). to install the PMK 300 in this
configuration, slide the bracket up from the bottom of the pole before
the projector is installed on the pole.
Side Mounting
Plate
Extron
USB Extender
Receiver
Power Supply
Extron
PMK 300
Multi-product Pole Mount Kit
Front Mounting
Plate
USB Extenders • Reference Information
23
Advertisement
Table of Contents
