Table of Contents
Advertisement
Under-Furniture Mounting
the unit can be mounted under a horizontal surface using an optional MBU 123,
Under-Desk Mount Kit for 1/8 and 1/4 Rack Width products, (part #70-212-01).
Mount the unit under a desk or table as follows:
1.
Secure the under-desk mounting brackets to the transmitter or receiver with the four
machine screws provided in the mounting kit (figure 14).
2.
Hold the transmitter or receiver with attached brackets against the underside of the desk
or other furniture. Mark the location of holes for screws on the desk.
3.
Drill 1/4 inch (6.4 mm) deep, 3/32 inch (2 mm) diameter pilot holes in the table or desk
at the marked screw locations from the underside or inside (the concealed side) of the
furniture, where the transmitter or receiver will be located.
4.
Insert the four wood screws into the pilot holes. Fasten each screw into the installation
surface until slightly less than 1/4 inch of the screw head protrudes.
5.
Align the installed screws with the slots in the mounting brackets, and place the
transmitter or receiver against the surface, with the screws through the bracket slots.
6.
Slide the transmitter or receiver slightly forward or back, then tighten all four screws to
fasten it in place.
Figure 14.
Under-Desk Mounting
USB Extenders • Reference Information
21
Advertisement
Table of Contents
