Table of Contents
Advertisement
6.
Assemble the U-bolt and the following parts in this order (see figure 19):
a.
Pass the legs of the U-bolt through the slotted holes on the mount plate flange.
b.
Place the legs around the projector pole.
c.
Pass the legs through the holes in the contoured base.
NOtE: the pole fits snugly into the depression in the center of the contoured
base.
d.
Pass the legs through the holes in the L-shaped bracket.
NOtE: the supplied U-bolt fits a typical (1.5 inch to 2.0 inch diameter)
ceiling pole.
Mount Plate
Flange
ä
U-bolt
ã
¨
Slotted Hole
in PMK Tray
Ceiling
Pole
Figure 19.
Hanging the Tray On the Pole
7.
Align the two slotted holes in the bottom of the L-shaped bracket with the two slotted
holes in the base of the tray. Secure the L-shaped bracket to the base by inserting two
provided 6-32 x 5/16 inch screws through the aligned slots.
8.
Move the PMK 350 to the desired location on the ceiling pole, as close to the ceiling as
desired.
9.
Secure the L-shaped bracket to the U-bolt using the included hex nuts, washers, and
lock washers. tighten the hex nuts securely.
NOtE: Be sure to tighten the hex nuts securely enough to prevent the PMK 350
sliding on the ceiling pole. A socket wrench is recommended to tighten
the hex nuts.
10.
Secure the front and rear plates to the mounting tray with four of the included
#6 screws (see figure 18).
11.
If desired, choose one of the provided four sizes of self-adhesive cover sheets, and apply
it to the underside of the mounting tray.
Contoured
Base
L-shaped
Bracket
G
Hex
Nuts (2)
USB Extenders • Reference Information
g
Align Slotted
Holes with
L-shaped
Bracket
L-shaped
Bracket Screws (2)
26
Advertisement
Table of Contents
