Cabling And Set Up - Extron electronics TP Series User Manual

Cabling and Set Up

to ensure proper operation, the transmitter, receiver, USB host, and USB peripherals must
be connected properly and in the sequence described below. connections are the same
regardless of which version is being installed.
NOtE: If the USB Host is capable of powering the transmitter (0.4 A max), the
PC
USB
Transmitter
HOST
POWER
12V
0.4A MAX.
DO NOT
CONNECT
TO LAN
The receiver must have a power supply connected.
If the USB host is capable of supplying power,
the transmitter supply is not required.
Ground
+12 VDC
Figure 7.
Power down the USB host Pc or laptop that will be connected to the transmitter and all
peripherals and devices that will be connected to the receiver.
If an external supply powers the transmitter:
1.
2.
3.
4.
5.
external supply for the transmitter is not required.
UTP or STP CAT5 or better cable.
Terminate both ends identically, in accordance with
either the TIA/EIA T 568A or the TIA/EIA T 568B
wiring standard.
LINK
External
Power Supply
(12 VDC, 1 A )
USB Extender Connection guide with Two External Supplies
connect twisted pair cable between the USB Extender transmitter and receiver.
connect one included power supply to the USB Extender receiver and one to the
transmitter, then apply power. the power LEDs on the receiver and transmitter light.
Additionally, with both units powered, the link LEDs light to indicate connectivity on the
twisted pair link.
connect a type A-B USB cable from the USB host to the USB Extender transmitter.
Apply power to the USB host. After the host has booted, the transmitter host LED blinks
to indicate communications between the host and transmitter. Shortly after, the host
LED on the receiver blinks to indicate the host is communicating with the hub controller
(USB Extender receiver).
connect USB peripherals (keyboard, mouse, scanner, printer, or other USB devices) to
the receiver. As each peripheral is recognized by the host, the respective USB hub port
LED lights.
Keyboard
Receiver
POWER
12V
1.0A MAX.
1
DO NOT
2
CONNECT
TO LAN
LINK
Four USB 2.0 compatible type A
female connectors provide +5 VDC
at up to 500 mA to connected USB
peripherals.
Ground
+12 VDC
USB Extenders • Installation and Operation
USB
HUB
3
4
External
Power Supply
(12 VDC, 1 A )
10