Table of Contents
Advertisement
PMK 350 mounting
Mount the receiver to a PMK 350 bracket as follows:
1.
Remove the front and rear plates from the PMK 350 (see figure 18), using an Extron
tweeker or a #2 Phillips screwdriver. Retain the screws to reattach the plates when
finished.
Rear Plate
Extron
PMK 350
Multi-product Pole
Mount Kit
Figure 18.
PMK 350 Projector Mounting a Receiver
2.
If necessary, remove the feet from the bottom of the receiver.
3.
Secure the receiver to one side of the mounting tray, using two of the supplied
4-40 x 3/16 inch screws in opposite (diagonal) corners.
4.
If a power supply is connected to the receiver, use the two included tie wraps to strap
the power supply to the bracket.
5.
Place the PMK 350 around the projector ceiling mounting pole.
U-bolt
Extron
Power Supply
Cover Sheet
USB Extenders • Reference Information
USB
Extender Rx
Contoured
Base
L-shaped
Bracket
Front Plate
25
Advertisement
Table of Contents
