Cisco Catalyst 2960 Command Reference Manual page 251

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
This example shows how to assign the ingress bandwidths for the queues. Queue 1 is the priority queue
with 10 percent of the bandwidth allocated to it. The bandwidth ratio allocated to queues 1 and 2 is
4/(4+4). SRR services queue 1 (the priority queue) first for its configured 10 percent bandwidth. Then
SRR equally shares the remaining 90 percent of the bandwidth between queues 1 and 2 by allocating 45
percent to each queue:
Switch(config)# mls qos srr-queue input priority-queue 1 bandwidth 10
Switch(config)# mls qos srr-queue input bandwidth 4 4
You can verify your settings by entering the show mls qos interface [interface-id] queueing or the show
mls qos input-queue privileged EXEC command.
Related Commands Command
mls qos srr-queue input buffers
mls qos srr-queue input cos-map
mls qos srr-queue input dscp-map
mls qos srr-queue input priority-queue
mls qos srr-queue input threshold
show mls qos input-queue
show mls qos interface
OL-8604-03
Description
Allocates the buffers between the ingress queues.
Maps class of service (CoS) values to an ingress queue or
maps CoS values to a queue and to a threshold ID.
Maps Differentiated Services Code Point (DSCP) values
to an ingress queue or maps DSCP values to a queue and
to a threshold ID.
Configures the ingress priority queue and guarantees
bandwidth.
Assigns weighted tail-drop (WTD) threshold percentages
to an ingress queue.
Displays ingress queue settings.
queueing Displays quality of service (QoS) information.
mls qos srr-queue input bandwidth
Catalyst 2960 Switch Command Reference
2-225