Cisco Catalyst 2960 Command Reference Manual page 491

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
Table 2-30
Field
VLAN
Name
Status
Ports
Type
SAID
MTU
Parent
RingNo
BrdgNo
Stp
BrdgMode
Trans1
Trans2
Remote SPAN VLANs
Primary/Secondary/
Type/Ports
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs
Number of existing VTP VLANs
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 2
VLAN Name
---- -------------------------------- --------- -------------------------------
2
VLAN Type
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
2
Remote SPAN VLAN
----------------
Disabled
OL-8604-03
show vlan Command Output Fields
Description
VLAN number.
Name, if configured, of the VLAN.
Status of the VLAN (active or suspend).
Ports that belong to the VLAN.
Media type of the VLAN.
Security association ID value for the VLAN.
Maximum transmission unit size for the VLAN.
Parent VLAN, if one exists.
Ring number for the VLAN, if applicable.
Bridge number for the VLAN, if applicable.
Spanning Tree Protocol type used on the VLAN.
Bridging mode for this VLAN—possible values are source-route bridging
(SRB) and source-route transparent (SRT); the default is SRB.
Translation bridge 1.
Translation bridge 2.
Identifies any RSPAN VLANs that have been configured.
—
VLAN0200
SAID MTU
enet 100002 1500
: 45
: 45
Status Ports
active Gi0/1, Gi0/2
Parent RingNo BridgeNo Stp
- - -
Catalyst 2960 Switch Command Reference
BrdgMode Trans1 Trans2
- - 0 0
show vlan
2-567