Cisco Catalyst 2960 Command Reference Manual page 291

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Examples This example shows how to create a policy map called policy1. When attached to the ingress port, it
matches all the incoming traffic defined in class1, sets the IP DSCP to 10, and polices the traffic at an
average rate of 1 Mb/s and bursts at 20 KB. Traffic exceeding the profile is marked down to a DSCP
value gotten from the policed-DSCP map and then sent.
Switch(config)# policy-map policy1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# set dscp 10
Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit
Switch(config-pmap-c)# exit
This example shows how to configure multiple classes in a policy map called policymap2:
Switch(config)# policy-map policymap2
Switch(config-pmap)# class class1
Switch(config-pmap-c)# set dscp 10
Switch(config-pmap-c)# police 1000000 20000 exceed-action policed-dscp-transmit
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class2
Switch(config-pmap-c)# trust dscp
Switch(config-pmap-c)# police 1000000 20000 exceed-action drop
Switch(config-pmap-c)# exit
Switch(config-pmap)# class class3
Switch(config-pmap-c)# set dscp 0 (no policer)
Switch(config-pmap-c)# exit
This example shows how to delete policymap2:
Switch(config)# no policy-map policymap2
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands Command
class
class-map
service-policy
show policy-map
OL-8604-03
Description
Defines a traffic classification match criteria (through the police, set, and
trust policy-map class configuration command) for the specified class-map
name.
Creates a class map to be used for matching packets to the class whose name
you specify.
Applies a policy map to a port.
Displays QoS policy maps.
Catalyst 2960 Switch Command Reference
policy-map
2-265