Cisco Catalyst 2960 Command Reference Manual page 103

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
If you enter the dot1x control-direction in interface configuration command to enable unidirectional
control, this appears in the show dot1x all command output:
ControlDirection
If you enter the dot1x control-direction in interface configuration command and the port cannot support
this mode due to a configuration conflict, this appears in the show dot1x all command output:
ControlDirection
Related Commands Command
show dot1x
interface-id]
OL-8604-03
= In
= In (Disabled due to port settings)
Description
[all | interface Displays control-direction port setting status for the specified
interface.
dot1x control-direction
Catalyst 2960 Switch Command Reference
2-77