Debug Mac-Notification - Cisco Catalyst 3750 Command Reference Manual

Hide thumbs Also See for Catalyst 3750:
Table of Contents

Advertisement

debug mac-notification

debug mac-notification
Use the debug mac-notification privileged EXEC command to enable debugging of MAC notification
events. Use the no form of this command to disable debugging output.
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.1(11)AX
Usage Guidelines
The undebug mac-notification command is the same as the no debug mac-notification command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands
Command
show debugging
show mac
address-table
notification
Catalyst 3750 Switch Command Reference
B-16
debug mac-notification
no debug mac-notification
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Displays the MAC address notification information for all interfaces or the
specified interface.
Appendix B
Catalyst 3750 Switch Debug Commands
78-16181-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents