Cisco Catalyst 3750 Command Reference Manual page 420

show vlan
Table 2-28 show vlan Command Output Fields (continued)
Field
BrdgNo
Stp
BrdgMode
Trans1
Trans2
Remote SPAN VLANs
Primary/Secondary/
Type/Ports
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs
Number of existing VTP VLANs
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 2
VLAN Name
---- -------------------------------- --------- -------------------------------
2
VLAN Type
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
2
Remote SPAN VLAN
----------------
Disabled
This is an example of output from the show vlan internal usage command. It shows that VLANs 1025
and 1026 are being used as internal VLANs for Fast Ethernet routed ports 23 and 24 on stack member
1. If you want to use one of these VLAN IDs, you must first shut down the routed port, which releases
the internal VLAN, and then create the extended-range VLAN. When you start up the routed port,
another internal VLAN number is assigned to it.
Switch> show vlan internal usage
VLAN Usage
---- -------------
1025 FastEthernet1/0/23
1026 FastEthernet1/0/24
Catalyst 3750 Switch Command Reference
2-394
Description
Bridge number for the VLAN, if applicable.
Spanning Tree Protocol type used on the VLAN.
Bridging mode for this VLAN—possible values are source-route bridging
(SRB) and source-route transparent (SRT); the default is SRB.
Translation bridge 1.
Translation bridge 2.
Identifies any RSPAN VLANs that have been configured.
Not applicable to this release.
VLAN0200
SAID MTU
enet 100002 1500
: 45
: 45
Status Ports
active Fa1/0/7, Fa1/0/8
Gi3/0/1, Gi3/0/2
Parent RingNo BridgeNo Stp
- - -
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
BrdgMode Trans1 Trans2
- - 0 0
78-16181-01