Cisco Catalyst 3750 Command Reference Manual page 263

Hide thumbs Also See for Catalyst 3750:
Table of Contents

Advertisement

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
Examples
This is an example of output from the setup command:
Switch# setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Configuring global parameters:
Enter host name [Switch]: host-name
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: enable-secret-password
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: enable-password
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: terminal-password
Configure SNMP Network Management? [no]: yes
Community string [public]:
Current interface summary
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Vlan1
GigabitEthernet6/0/1
GigabitEthernet6/0/2
<output truncated>
Port-channel1
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: ip_address
Subnet mask for this interface [255.0.0.0]: subnet_mask
Would you like to enable as a cluster command switch? [yes/no]: y es
Enter cluster name: cluster-name
78-16181-01
IP-Address
OK? Method Status
172.20.135.202
YES NVRAM
unassigned
YES unset
unassigned
YES unset
unassigned
YES unset
up
up
up
up
Catalyst 3750 Switch Command Reference
setup
Protocol
up
up
down
down
2-237

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents