Cisco Catalyst 3750 Command Reference Manual page 316

show interfaces
Command Modes
Privileged EXEC
Command History Release
12.1(11)AX
12.1(14)EA1
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
•
•
•
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show interfaces command for Gigabit Ethernet interface 3 on
stack member 3:
Switch# show interfaces gigabitethernet3/0/2
GigabitEthernet3/0/2 is down, line protocol is down
Hardware is Gigabit Ethernet, address is 0009.43a7.d085 (bia 0009.43a7.d085)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Catalyst 3750 Switch Command Reference
2-290
Modification
This command was introduced.
Support for the capabilities keyword was added.
Entering show interface capabilities module number displays the capabilities of all interfaces on
that switch in the stack. If there is no switch with that module number in the stack, the output is
blank.
Entering show interfaces interface-id capabilities displays the capabilities of the specified
interface.
Entering show interfaces capabilities (with no module number or interface ID) displays the
capabilities of all interfaces in the stack.
reliability 255/255, txload 1/255, rxload 1/255
2 packets input, 1040 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
4 packets output, 1040 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
78-16181-01