Mac Address-Table Aging-Time - Cisco Catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

mac address-table aging-time

Use the mac address-table aging-time global configuration command on the switch stack or on a
standalone switch to set the length of time that a dynamic entry remains in the MAC address table after
the entry is used or updated. Use the no form of this command to return to the default setting. The aging
time applies to all VLANs or a specified VLAN.
Note Beginning with Cisco IOS Release 12.1(19)EA1, the mac address-table aging-time command replaces
the mac-address-table aging-time command (with the hyphen).
Syntax Description 0
10-1000000
vlan vlan-id
Defaults The default is 300 seconds.
Command Modes Global configuration
Command History Release
12.1(11)AX
12.1(19)EA1
Usage Guidelines If hosts do not send continuously, increase the aging time to record the dynamic entries for a longer time.
Increasing the time can reduce the possibility of flooding when the hosts send again.
If you do not specify a specific VLAN, this command sets the aging time for all VLANs.
Examples This example shows how to set the aging time to 200 seconds for all VLANs:
Switch(config)# mac address-table aging-time 200
You can verify your setting by entering the show mac address-table aging-time privileged EXEC
command.
78-16181-01
mac address-table aging-time {0 | 10-1000000} [vlan vlan-id]
no mac address-table aging-time {0 | 10-1000000} [vlan vlan-id]
This value disables aging. Static address entries are never aged or removed from
the table.
Aging time in seconds. The range is 10 to 1000000 seconds.
(Optional) Specify the VLAN ID to which to apply the aging time. The range is
1 to 4094.
Modification
This command was introduced.
The mac-address-table aging-time command was replaced by the mac
address-table aging-time command.
mac address-table aging-time
Catalyst 3750 Switch Command Reference
2-135