Show Ipc - Cisco Catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
Command History Release
12.1(11)AX
12.2(18)SE
Usage Guidelines
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This example shows how to display the IPC routing status:
Switch> show ipc mcast status
Total Frames
Total control Frames
Total Frames dropped
Total control Frames dropped
Total Reliable messages
Total Reliable messages acknowledged
Total Out of Band Messages
Total Out of Band messages acknowledged
Total No Mcast groups
Total Retries
Total OOB Retries
Total flushes
This example shows how to display the participating nodes:
Switch> show ipc nodes
There is 1 node in this IPC realm.
ID
10000 Local
This example shows how to display the local IPC ports:
Switch> show ipc ports
There are 8 ports defined.
Port ID
There are 8 ports defined.
10000.1
10000.2
10000.3
10000.4
10000.5
10000.6
10000.7
0/2/159
78-16181-01
Modification
This command was introduced.
The mcast {appclass | groups | status}, rpc, session {all | rx | tx}
[verbose], and cumulative keywords were added.
IPC Mcast Status
Type Name
IPC Master
Type Name
unicast IPC Master:Zone
unicast IPC Master:Echo
unicast IPC Master:Control
unicast IPC Master:Init
unicast FIB Master:DFS.process_level.msgs
unicast FIB Master:DFS.interrupt.msgs
unicast MDFS RP:Statistics
port_index = 0 seat_id = 0x10000
Tx
0
0
0
0
0
0
0
0
0
0 Total Timeouts
0 Total OOB Timeouts
0 Total No ports
Last Last
Sent Heard
0 0
(current/peak/total)
last sent = 0
Catalyst 3750 Switch Command Reference

show ipc

Rx
0
0
0
0
0
0
0
0
0
0
0
0
last heard = 0
2-309