Debug Platform Snmp - Cisco Catalyst 3750 Command Reference Manual

debug platform snmp

debug platform snmp
Use the debug platform snmp privileged EXEC command to enable debugging of the
platform-dependent Simple Network Management Protocol (SNMP) software. Use the no form of this
command to disable debugging output.
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines The undebug platform snmp command is the same as the no debug platform snmp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands Command
show debugging
Catalyst 3750 Switch Command Reference
B-52
debug platform snmp
no debug platform snmp
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, refer to the Cisco IOS Release 12.2 Configuration
Guides and Command References > Cisco IOS Configuration
Fundamentals Configuration Guide, Release 12.2 > System Management
> Troubleshooting and Fault Management.
Appendix B Catalyst 3750 Switch Debug Commands
78-16181-01