Snmp-Server Host - Cisco Catalyst 3750 Command Reference Manual

snmp-server host

snmp-server host
Use the snmp-server host global configuration command on the switch stack or on a standalone switch to
specify the recipient (host) of a Simple Network Management Protocol (SNMP) notification operation.
Use the no form of this command to remove the specified host.
Syntax Description host-addr
udp-port port
informs | traps
version 1 | 2c | 3
community-string
bgp
bridge
cluster
config
copy-config
entity
Catalyst 3750 Switch Command Reference
2-410
snmp-server host host-addr [udp-port port] [informs | traps] [version {1 | 2c | 3 [auth | noauth|
priv]}] {community-string [[bgp ] [bridge] [cluster] [config] [copy-config] [entity] [envmon]
[flash] [fru-ctrl] [hsrp] [ipmulticast] [mac-notification] [mdsp] [pim] [port-security] [rtr]
[snmp] [stpx] [syslog] [tty] [vlancreate] [vlandelete] [vlan-membership] [ vtp]]}
no snmp-server host host-addr [udp-port] [informs | traps] [version {1 | 2c | 3 [auth | noauth |
priv]}] community-string
Name or Internet address of the host (the targeted recipient).
(Optional) Configure the User Datagram Protocol (UDP) port number of the
host to receive the traps. The port-number range is from 0 to 65535.
(Optional) Send SNMP traps or informs to this host.
(Optional) Version of the Simple Network Management Protocol (SNMP)
used to send the traps.
These keywords are supported:
1—SNMPv1. This option is not available with informs.
2c—SNMPv2C.
3—SNMPv3. These optional keywords can follow the Version 3 keyword:
•
•
•
Note
Password-like community string sent with the notification operation. Though
you can set this string by using the snmp-server host command, we
recommend that you define this string by using the snmp-server community
global configuration command before using the snmp-server host
command.
(Optional) Send Border Gateway Protocol (BGP) state change traps.
Note
(Optional) Send SNMP Spanning Tree Protocol (STP) bridge MIB traps.
(Optional) Send cluster member status traps.
(Optional) Send SNMP configuration traps.
(Optional) Send SNMP copy configuration traps.
(Optional) Send SNMP entity traps.
auth (Optional). Enables Message Digest 5 (MD5) and Secure Hash
Algorithm (SHA) packet authentication.
noauth (Default). The noAuthNoPriv security level. This is the default
if the [auth | noauth | priv] keyword choice is not specified.
priv (Optional). Enables Data Encryption Standard (DES) packet
encryption (also called privacy).
The priv keyword is available only when the crypto (encrypted)
software image is installed.
This keyword is available only when the enhanced multilayer image
is installed on the stack master.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
78-16181-01