Korg M50-88 Parameter Manual page 72

Program mode
Send 1
Send 2
These specify the send level at which the output of the drum
track program will be sent to each master effect.
Send 1: Send the signal to master effect 1.
Send 2: Send the signal to master effect 2.
If Bus (IFX/Output) Select is set to IFX1–5, the send levels to
the master effects are set by the post-IFX1–5 Send1 and
Send2 (Prog 8–2a).
You can use CC#93 to control Send 1, and CC#91 to
control Send 2.
IFX. Patch:
IFX1
IFX2
IFX3
IFX4
IFX5
Here, you can patch the Bus (IFX/Output) Select setting
specified for each key of the drum kit, temporarily changing
its connection destination from the originally specified
insert effect to some other destination. This can be executed
only if the drum track program's Bus (IFX/Output) Select is
set to DKit and the Bus (IFX/Output) Select (Global 5–4b)
for each key of the drum kit is set to IFX1–5.
As the patch destination, choose an insert effect or L/R,
IFX1–5, or Off as the output bus.
Note: If you want to return the drum kit to its previous state,
change these settings to IFX1→IFX1, IFX2→IFX2,
IFX3→IFX3, IFX4→IFX4, and IFX5→IFX5.
For the preloaded kits, snare sounds are normally sent to
IFX1, kick sounds to IFX2, and other sounds to IFX3. In such
cases if you set Bus (IFX/Output) Select to Dkit, these
sounds will be sent to IFX1, IFX2, and IFX3, but IFX1 and
IFX2 are set for normal (non-drum) programs. In such cases,
you can use IFX.Patch to route these drum sounds to
unused IFX; for example, you might send the snare sounds
to IFX3, kick sounds to IFX4, and other sounds to IFX5. For
more information, please see "Effect Guide" on page 271.
▼7–5: Menu Command
• 0: Write Program ☞p.73
• 1: Exclusive Solo ☞p.73
• 2: Copy Drum Track ☞p.74
• 3: Erase Drum Track Pattern ☞p.75
For more information, please see "Program: Menu
Command" on page 73.
64
[000...127]
[000...127]
[L/R, IFX1...5, Off]
[L/R, IFX1...5, Off]
[L/R, IFX1...5, Off]
[L/R, IFX1...5, Off]
[L/R, IFX1...5, Off]