Lan Select; Lan Setup; Dhcp - Speco DVR-4TN User Manual

5.1.6.1

LAN Select

PPPoE stands for Point-to-Point Protocol over Ethernet, which is a
specification for connecting the users by Ethernet to the Internet through a
common broadband medium.
This item allows you to select your service type between <LAN>, <PPPoE> or
<None>; if you are using an intranet for communication, please select <LAN>,
if you are using a broadband medium, such as DSL Line or cable modem,
please select <PPPoE>.
If <None> is selected, then there is no need to set further LAN setting,
therefore, the second item <LAN Setup> will not be accessible.
5.1.6.2

LAN Setup

The network related settings in the LAN Setup menu should be associated
with the network service type. If you select <LAN> for <LAN Select>, then 6
th
to 8
Select <LAN Setup> in Network Setup menu and press ENTER for setting the
parameters; the menu displays as follows.

1. DHCP

2. IP
3. Netmask
4. Gateway
5. DNS
6. PPPoE Account
7. PPPoE Password
8. PPPoE Max Idle
9. Router Setting
10. Connect At Booting
11. Network Restart
DHCP
This item allows the user to obtain a dynamic IP address from a DHCP
(Dynamic Host Configuration Protocol) server while the unit boots up. When
using DHCP, the settings are dynamic and they will change every time you
power up and power off the unit, depending on your network's setup.
If the DHCP is enabled (ON), a dynamic IP will be assigned to the DVR-4TN/
8TN/ 16TN/ 16TS/ 16TT series unit. In this case, the user does not need to
configure a static IP or the Ethernet settings including IP address, Netmask,
Gateway, and DNS settings will be "read only". The default setting is <ON>.
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/08
item will not be available.
LAN Setup
User's Manual
OFF
192.168.1.150
255.255.255.0
192.168.1.1
0.0.0.0
35min
YES
NO
th
61