Remote Surveillance; Mobile Client Surveillance; Web Lan Access - Speco H16HRL User Manual

Remote Surveillance

12.1 Mobile Client Surveillance

① Enable NAT in the DVR. Refer to 11.1.8 NAT Configuration for details.
② Scan the QR Code through the Speco Blue App available for iOS and Android to easily and securely view your cameras.
③ Run the mobile client, go to the "Add Device" interface and then click
StartSettingsSystemInformationBasic to view the QR Code of the DVR).
④ After scanning the QR Code successfully, enter the login password to log in mobile client.

12.2 Web LAN Access

① Click StartSettingsNetworkTCP/IP to go to the "TCP/IP" interface. Set the IP address, subnet mask, gateway, preferred DNS and
alternate DNS of the DVR.
② Open the web browser on your computer, enter the IP address of the DVR in the address bar and then press enter to go to the login interface
as shown below. You can change the display language on the top right corner of the login interface. Enter the username and password of the DVR
in the interface and then click "Login" to go to the live view interface.
12 Remote Surveillance
Notes: 1. Please make sure that the IP address of the DVR and the computer are both in the same local
network segment. For example, supposing that the IP address of the computer is 192.168.1.41,
the IP address of the DVR shall be set to 192.168.1.XXX.
2. If the HTTP port of the DVR is not 80, but other number instead, you need to input the IP
address plus port number in the IE address bar when accessing the DVR over network. For
example, the HTTP port is 81. You should enter http://192.168.1.42:81 in the IE address bar.
to scan the QR Code of the DVR (Go to
79
DVR User Manual