Problems Relating To Images - Epson EMP-835 User Manual

Problem Solving

Problems Relating to Images

No images appear
Check
Was the [Power] button pressed?
Is the A/V Mute function active?
Have the configuration menu settings been
made correctly?
Is the projected image completely black?
Only when projecting computer images
Are the image signal format settings correct? If a
Only when projecting images
from a video source
Projection stops automatically
Check
Is "Sleep Mode" set to "ON"?
Press the [Power] button on either the remote control or the projector's control panel to turn the
power on.
The remote control cannot be used unless the [R/C] switch of the remote control is at "ON".
sp.34
Press the [A/V Mute] button on either the remote control or the projector's control panel to cancel
sp.55
the A/V Mute function.
sp.86
Reset all of the settings.
Some input images, such as screen savers, may be completely black.
composite videog or S-Videog
menu command to select the signal format. s"Signal" - "Video Signal"
When the "Sleep Mode" menu command has been set to "ON", the lamp turns off automatically if
no operations are carried out for about 30 minutes while no image signal is being input. The Power
indicator lights orange at this time. Press the [Power] button on either the remote control or the
projector's control panel to turn the power on. If you do not want sleep mode to be used, change the
"Sleep Mode" setting to "OFF". s"Extended" - "Operation" - "Sleep Mode"
Remedy
source is connected to the projector, use the "Video Signal"
Remedy
User's Guide
101
p.81
p.85