Epson EMP-835 User Manual page 98

Problem Solving
Status
Fan related error
Red
Sensor error
Red
Lamp error
Red
Lamp timer failure
Lamp out
Red
Lamp cover is open
Internal temperature error
Red
(overheating)
Red
Cause
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your
dealer or the nearest address provided in the "International Warranty Conditions" section of the
Safety Instructions/World-Wide Warranty Terms booklet.
Take out the lamp and check if it is broken. s"Replacing the Lamp"
If the lamp is not broken, put it back in and then turn the power on. If the lamp still does not turn
on, replace it with a new lamp.
If this does not solve the problem, stop using the projector and disconnect the power cable from the
electrical outlet. Then contact your dealer or the nearest address provided in the "International
Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
If the lamp is broken, contact your local dealer for further advice.
(Projection cannot be carried out until the lamp is replaced.)
Check that the lamp and the lamp cover are securely installed. If the lamp or lamp cover is not
securely installed, the lamp will not switch on.
The lamp will turn off automatically and projection will stop. Wait for about 5 minutes without
operating the projector. After about 5 minutes have elapsed, unplug the power cable and then
check the following two points.
•Check that the air filters and air exhaust vent are clear, and that the projector is not positioned
against a wall.
•If the air filters are blocked, clean or replace them.
When the power cable is plugged back in, the projector will return to its previous state, so press the
[Power] button on either the projector's control panel or the remote control to turn it back on. If the
projector continues to overheat even after the above points have been checked, or if the indicators
show a problem when the power is turned back on, stop using the projector, disconnect the power
cable from the electrical outlet, and contact your dealer or the nearest address provided in the
"International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms
booklet.
Remedy or Status
sp.15
: lit : flashing
p.121
sp.119
User's Guide
97
: off