Problems Relating To Images - Epson EH-TW5650 User Manual

Troubleshooting
Problems with HDMI
Network problems
Bluetooth device prob-
lems
Other problems
* Because color reproduction differs between monitors and computer LCD screens, the image projected by the
projector and the color tones displayed on the monitor may not match, however this is not a fault.

Problems relating to images

No images appear
Check
Is the projector turned on?
Is the power cord connected?
Are the indicators switched off?
Is an image signal being input?
Are the Configuration menu settings correct? Reset all of the settings.
(Only when projecting computer image sig-
nals)
Was the connection made while the power of
the projector or the computer was already
turned on?
Moving images are not displayed
Check
(Only when projecting computer image sig-
nals)
Is the computer's image signal set to external
output and to output to the LCD monitor at
the same time?
Problem
HDMI Link does not function.
The device name is not displayed under device connections.
Cannot access the network via wireless LAN.
The image contains static during network projection.
Cannot connect using Screen Mirroring.
The image contains static during Screen Mirroring connection.
Cannot connect Bluetooth device.
The audio and connection for the Bluetooth device disconnects.
No audio, or the audio is too low.
Cannot make settings on the control panel.
Slideshow does not start.
Press the
Connect the power cord.
Disconnect and then reconnect the projector's power cord.
Check that pressing the power button after connection supplies
the projector with power.
Check that the connected device is turned on. When Messag-
es is set to On from the Configuration menu, image signal mes-
sages are displayed.
If the connection is made while the power is already turned on,
the Fn key (Function key) that switches the computer's image
signal to external output may not work. Turn off the power for
the computer and the projector and then turn it back on again.
Depending on the computer's specifications, moving images
may not be displayed when the computer is set to external out-
put and to the LCD monitor output at the same time.
Switch it so that the image signal is set to external output only.
For the computer's specifications, see the documentation sup-
plied with the computer.
Remedy
button on the remote control or the control panel.
Extended - Display - Messages
s
Reset - Reset All
s
Remedy
81
Page
p.85
p.86
p.86
p.86
p.87
p.87
p.87
p.88
p.88
p.88
p.89
p.71
p.76