Table of Contents
Advertisement
Troubleshooting
Problems with USB storage
devices
Other problems
*
Because color reproduction differs between monitors and computer LCD screens, the image projected by the
projector and the color tones displayed on the monitor may not match, however this is not a fault.
Problems relating to images
No images appear
Check
Is the projector turned on?
Is the power cable connected?
Are the indicators switched off?
Is an image signal being input?
Is the image signal format setting correct?
Are the configuration menu settings correct? Reset all of the settings.
(Only when projecting computer image sig-
nals)
Was the connection made while the power of
the projector or the computer was already
turned on?
Moving images are not displayed
Check
(Only when projecting computer image sig-
nals)
Is the computer's image signal set to external
output and to output to the LCD monitor at
the same time?
Problem
Slideshow does not start
No audio, or the audio is too low.
Press the
on the control panel.
Connect the power cable.
Disconnect and then reconnect the projector's power cable.
Check that power is being supplied.
Check that the connected device is turned on. When Messag-
es is set to On from the configuration menu, image signal mes-
sages are displayed.
When Video is input
If nothing is projected even when Video Signal is set to Auto
from the configuration menu, set the signal that matches the
connected device.
nal
p.73
When Component is input
If nothing is projected even when Component is set to Auto
from the configuration menu, set the signal that matches the
connected device.
nent
p.73
If the connection is made while the power is already turned on,
the key (Function key and so on) that changes the computer's
image signal to external output may not work. Turn off the power
for the computer and the projector and then turn it back on
again.
Depending on the computer's specifications, moving images
may not be displayed when the computer is set to external out-
put and to the LCD monitor output at the same time.
Change it so that the image signal is set to external output only.
For the computer's specifications, see the documentation sup-
plied with the computer.
Remedy
button on the remote control or the
Extended - Display - Messages
s
Extended - Input Signal - Video Sig-
s
Extended - Input Signal - Compo-
s
Reset - Reset All
s
Remedy
80
Page
p.87
p.87
button
p.73
p.75
Advertisement
Table of Contents
