Adjusting Computer Images; Automatic Setup - Epson EMP-835 User Manual

Adjusting Projected Images Manually

Adjusting Computer Images

Automatic Setup

Automatic setup detects analogue RGB signals coming from a computer
connected by a computer cable, and automatically adjusts these signals so
that the optimum images can be obtained.
The default setting for the automatic setup function is "ON", but if the
images are not displayed correctly or if "Signal" - "Auto Setup" in the
configuration menu is set to "OFF", press the [Auto] button on the remote
control or the [Enter] button on the projector's control panel while
computer (analogue-RGB) images are being projected to adjust the
images.
Remote control
Automatic setup involves adjustment of the following three items:
Tracking g Sync g
, Position and
been set to "Manual", it will change to "Auto".
Projector
. If the "Contrast" configuration menu has
TIP
• If you press the [Auto] button on the remote control or the [Enter]
button on the projector's control panel while the E-Zoom function or
Freeze function is active, the active function will be cancelled and
then the adjustment will be carried out.
• Sometimes the signals may not be adjusted correctly depending on
the type of signals being output by the computer. In such cases, use
the "Tracking", "Position" and "Sync." menu commands to make
the adjustments manually. sp.38, p.75,
• Automatic setup is not carried out while the preview function is
being used.
User's Guide
74
p.76