Projector Network Connecting Settings (Emp-830); Using A Network For Monitoring And Control - Epson EMP-835 User Manual

Monitoring and Controlling Projectors via a Network (for the EMP-830)

Using a Network for Monitoring and Control

Follow the procedure below to monitor and control the projector over a
network.
PROCEDURE
Install the software from the Projector Software CD-
1
ROM onto the computer that is to be used.
s"Installation and
Uninstallation" in the EMP
NetworkManager Operation Guide
Use a network cable to connect the projector to the
2
sp.24
network.
Use the projector's configuration menus to make the
3
sp.90
network settings.
It can be helpful to have EMP NetworkManager running while
making detailed settings.
Carry out monitoring and control operations from the
4
computer.
•Monitoring using the mail notification function
Mail Notification Function" and
Message has been Sent" in the EMP NetworkManager Operation
Guide
•Monitoring and control using EMP Monitor
Operation Guide
s"Setting the
"If a Problem Notification E-mail
sEMP Monitor

Projector Network Connecting Settings (EMP-830)

In order to connect a projector to a network, you will need to complete
various configuration menu settings such as setting an
projector.
TIP
Once the projector has been connected to the network, you can use
EMP NetworkManager to make detailed network settings for the
sEMP NetworkManager Operation Guide
projector.
The following settings can be carried out using the accessory remote
control.
PROCEDURE
Press the [Menu] button on the remote control, and
1
then select "Network" from the "Extended"
configuration menu.
s"Using the Configuration Menus" for details on this
operation. p.87
Move the cursor to the item to be set, and then press
2
the [Enter] button on the remote control.
Some items require numbers to be entered. Refer to "Entering
sp.92
Numbers" for details on entering numbers.
User's Guide
90
IP address g
for the