The Copier Is Not Functioning As Designed - Minolta CF910 Manual

7-4

2. The Copier is not functioning as designed

The Copier is not functioning as designed
Symptom
The Touch Panel shows nothing. Is only the Start Key lit up green? The copier is in the Energy Saver
The Start Key does not light up
green.
No copies are fed out when the
Start Key is pressed.
Control Panel Keys do not
respond.
The copier is not activated when
the Power Switch is turned ON.
If these procedures do not correct the problem, contact your Technical Representative.
check for:
The Display Contrast Control
Knob is placed in the excessively
light or dark position.
Is your Access Number entered? Enter your Access Number.
The copier was just turned ON
and is warming up.
The copier has developed a
malfunction.
The Interrupt Key LED is lit up.
The power cord is left unplugged
from the power outlet.
The room circuit breaker is open. Close the room circuit breaker.
Action
Mode.
Press any key on the Control
Panel to cancel the Energy Saver
Mode. p. 2-10
Viewing the Touch Panel, turn the
Display Contrast Control Knob as
necessary.
p. 2-11
1154P449CA
It takes the copier about 9
minutes to be ready for making
copies after it has been turned
ON.
Please wait.
Check the Touch Panel and take
action according to the message
on the Panel.
The copier is in the interrupt
mode.
Press the Interrupt Key to cancel
the interrupt mode.
Plug the power cord into the
power outlet.
p. 6-18
p. 2-10